Vulcan-Hart KleenScreen PLUS 2GR85DF Servisní příručka stáhnout pdf (Strana 11)

INTERFACE CONTROL - D and C

SERIES

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

1. Remove CONTROL PANEL.

2. Note lead wire locations and remove wiring.

3. Remove screws securing control to fryer and

remove.

Fig. 13

4. Reverse procedure to install and check for proper

operation.

POWER SWITCH - D and C SERIES

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

NOTE: This procedure is for solid state and computer

controls. Power switch for analog controls is part of the

analog control box.

1. Open fryer door to access power switch.

Fig. 14

2. Unplug power switch connector.

3. Reach behind power switch and press tabs on

both sides of power switch to remove switch.

NOTE: Power switch is removed from front of the

panel.

4. Reverse procedure to install new power switch.

5. Check operation of machine.

TEMPERATURE PROBE

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

1. Drain shortening from fryer tank.

VK and TR GAS FRYERS W/Wo KleenScreen PLUS - REMOVAL AND REPLACEMENT OF PARTS

Page 11 of 54 F45474 (0413)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 61 62

Žádné komentáře

Vulcan-Hart KleenScreen PLUS 2GR85DF Servisní příručka Strana 11